Trailer Wiring Harness Installation - 2003 Chrysler PT Cruiser- Video
Today our 2003 Chrysler PT Cruiser we'll be installing the Curt T-Connector Wiring Kit, part number C55532. To begin with we'll need to remove both tail light assemblies by removing the torxhead screw that's at the lower section on the tail light assembly. Once you pull the tail light assembly out, because careful not to break the clips off as you're removing the tail light assembly. Then we will go ahead and unplug both plugs from the rear of the assembly. On this case we used a small screw driver to help release both of the locking tabs. Once we have the passenger side light assembly out and the wires disconnected we will go ahead and drop down the 4-flat as well as the yellow wire with the connectors down through the light assembly and under the rear bumper fascia. We'll plug the grey connector that has two wires into it with the green wire into the vehicle's harness, making sure that the locking tabs snap into place. We will also make the connection with the plug that has three wires, one of them has a brown and red wire in it as well. more
11/10/2014 10:45:27 AM
