Best 2010 Buick Enclave Trailer Wiring Options- Video
Speaker 1: Today you're going to be taking a look at the best wiring options for your 2010 Buick Enclave. For your Enclave doesn't have the factory tow package, we're going to have a few different options for that. Over here we're going to have the CURT T-Connector wiring harness. Next to that we're going to have the Tekonsha wiring harness. Then finally over here we're going to have the Hopkins wiring harness.Now obviously they're all going to look a little bit different but the end result is going to give us a four-pole flat trailer connector that's going to provide all the lights to our trailer and safely get down the road.With our Tekonsha and our CURT, you can see they're going to look very similar. Really the main difference here is going to be the color of the wire. more
10/17/2018 9:58:03 AM
Trailer Wiring Harness Installation - 2010 Buick Enclave- Video
Today on our 2010 Buick Enclave we'll be taking a look at and installing a Curt T connector vehicle wiring harness with 4-pole, flat trailer connector, part number C56027. Now we're going to go ahead and test out our wiring. Go ahead and remove the cover, we'll hook up our ground, and then we're going to test out our running lights first which will be that brown wire. Running lights off. Now left turn signal, yellow wire, off, and passenger side, the green wire. Brakes, we'll get that constant signal on both our green, and our yellow. All right, our wires look good. First thing we'll do, go ahead and lift up that rear hatch to gain access to our taillight assemblies. more
12/21/2015 11:39:03 AM
Trailer Wiring Harness Installation- 2010 Buick Enclave- Video
Today on this 2010 Buick Enclave we are going to be installing wiring harness part number 118450. We are at the rear cargo area of the Enclave, and we are going to locate the ports that we are going to be plugging our wiring harness into. These ports are actually located directly behind the tail light assembly on both the driver and passenger side. So, the first thing we want to do is remove both tail light assemblies. To do that we are going to open up the rear cargo door, there are two inboard screws holding the tail light into place. We need to pull back the covers to expose those. :30 more
8/11/2010 7:53:10 AM
