Best 2009 Chevrolet Impala Custom Fit Vehicle Wiring Options- Video
Rob: Rob here at etrailer.com, and today you're going to be taking a look at the best trailer wiring options for your 2006 through 2013 Chevrolet Impala. Here we're going to have our CURT wiring, which is going to give us a four-pole flat trailer connector. Then over here we're going to have our Tekonsha wiring, which is also going to give us a four-pole flat trailer connector.Now if I was looking for wiring for my Impala, I personally would go with the CURT because a few little things that they give you that the Tekonsha doesn't in the packaging. Let's take a closer look at some of the features of both of them.Since both of our kits are going to give us that four-pole flat trailer connector, it's going to give us all the required lights to get down the road safely, like our taillights, turn signals, and our brake lights. As far as installation goes, it is going to be custom fit, so we're not going to have to worry about cutting or splicing with either one of our wiring kits. We're just going to have a simple T-connector that's going to plug inline behind our passenger side taillight.Now CURT's going to use the same T-style connector to plug in behind the passenger taillight, but they're going to provide you with some black silicone because there's a rubber grommet that we can cut a slit in, pass our wires through, and then our wiring is going to stay inside the trunk until we need it, whereas the Tekonsha is designed to stay on the outside. more
3/28/2019 1:07:15 PM
Trailer Wiring Harness Installation - 2009 Chevrolet Impala- Video
Today on our 2009 Chevrolet Impala, we'll be installing the Tow Ready T-One Connector Trailer Wiring, part number 118417. To begin with we'll need to open the trunk of the vehicle. All of the connections will be made on the passenger side so that's where we'll be working. Before we can begin, we need to remove the center threshold of the trunk. To do this, there are two tabs, one on each side that will need to be removed first. Then we'll pry the center threshold up either with a trim panel tool or with a large flat head screwdriver. Once you have the center threshold out of the way, now we'll need to remove three plastic tabs or nuts that hold the light assembly in on the passenger side. You'll need to pull the carpet back on the passenger side to expose the three plastic nuts that you'll need to remove. more
10/31/2014 10:04:00 AM
