Trailer Wiring Harness Installation - 2001 Toyota RAV4- Video
Today on this 2001 Toyota RAV4, we're going to install part number C55307. This is a Curt T-Connector trailer wiring harness with a floor pull flat. With our floor pulled back out, we'll go ahead and show you how to use it. Pull it out, you can go ahead and put the panel back into place. Then route this to the outside over the door seal here. The door seal's thick enough, it won't hurt anything when we shut the door on it. Set it by the center of the hitch, close the door, and we can go ahead and pull out what we need to go out to our trail. Let's go ahead and open it back up, and when we're not using it, we'll keep it in the compartment. That way it stays safe and not exposed to the elements. First thing we need to do is go ahead and open up the back door and we need to go ahead and loosen up and remove some interior panels. We'll also take our floor panel and we'll go ahead and just rotate towards the front. more
11/24/2014 5:08:01 PM
Trailer Hitch Wiring Harness - 2001 Toyota RAV4- Video
Today on this 2001 Toyota RAV4 we are going to install part number 118389, a t-one wiring harness. We will be removing the interior panels and trim to install the wiring harness behind the tail lights for the hitch. We will remove screws here, here, and here. Then work your way under the trim panel, and pop it free. This will allow you access behind the taillights. Repeat the same steps on the drivers side. :45 more
4/26/2011 3:54:20 PM
Trailer Wiring Harness Installation - 2001 Toyota RAV4 33465- Video
Today we are going to install part number 33465 from Hoppy, and we are going to install it on a 2001 Toyota RAV4. All right, to begin with we need to get inside the vehicle and we need to take off the plastic panels on the inside. I am going to take up this carpet and this panel also. We will just push that back for now. And this trim panel, it comes off also. And the next thing we need to do is take off this panel here. We need to loosen it so we can get behind the tail light assembly. We will take off this screw here, and then we will undo this screw here to take off this buckle so that gives you easier work room to pull off the plastic. Also, behind this panel there might be a screw that you might need to take out too. We will take off this panel here for a little bit extra room, too. more
9/11/2008 5:52:19 AM
