Best 2008 Audi Q7 Trailer Wiring Options- Video
Hi there, Audi owners. Today we're going to be taking a look at the best vehicle wiring options for our 2008 Audi Q7. Here we have our two best wiring options. The option on the left is the one from Curt and the option on the right is from Tekonsha and in most aspects, these wiring harnesses are going to be basically identical but there are a few minor differences between them and we'll cover those now.This is is our Tekonsha harness and as you can see, the module is relatively small which is nice to be able to fit it into smaller areas, versus our Curt here, which is quite a bit larger.As you can see here on our 2014 Audi Q7, we've got the smaller Tekonsha module installed and we're able to take our wiring and tuck it all up into the little compartment behind our taillight.Whereas, if we we're using our Curt, the Curt itself would take up just about all the space inside of our compartment here, leaving no place for our wiring, which would require us to have to route it to another location and store it somewhere else making it a lot more work for us.I will say, however, the Curt does have a higher output at five amps on these stop turn circuit, while our Tekonsha only has 4.2 amps on the stop turn. They both offer 7.5 amps on the taillights, so if you need that higher output for your stop and turn circuits on your trailer, if you've got a lot of lights, big light parts for your taillight assemblies, then the Curt may be the better option for you.Other than that, our harnesses are basically identically. They're gonna have the same outputs to make the connections to your vehicle. more
4/12/2019 2:27:11 PM
Trailer Wiring Harness Installation - 2008 Audi Q7- Video
Speaker 1: Today on our 2008 Audi Q7, we're gonna be taking a look at and I'm gonna show you how to install the curb power taillight converter with four pull flat trailer connector. Part number C59236.It is gonna come with a nice dust cap to help protect any of your connections from any dirt and debris. This is gonna give you all your proper lighting functions to safely tow your trailer. It's gonna give you a right turn signal, left turn signal, brake lights, running lights, and your ground.When in use, again, just hang it out. When not in use, you simply roll it up, and store it inside the panel. When you're ready to use it, you pull it out of your storage compartment, run it over the rubber seal, stay away from any latching points.Now that we've gone over some of the features, let me show you how to get it installed.You look right up here in this corner, all of your wires from your taillights run down on both sides. more
10/29/2018 1:27:52 PM
