Trailer Wiring Harness Installation - 2009 Chrysler 300- Video
Today on our 2009 Chrysler 300 we'll be installing the Tow Ready T1 Vehicle wiring harness with four-pole flat trailer connector, part number 118406. To begin with, we'll go ahead and open up the trunk. Both on the driver and the passenger side, there's a small plastic wing nut that'll need to be removed and the carpet pulled back to gain access to the wiring connections. Now that we have both of these removed and the carpet pulled back some, we'll go ahead and start on the passenger side. Before we can remove the factory wiring connection, we need to pull the red tab, which is the locking tab, to the open position on the connection. With that done, we'll go ahead and squeeze the small tab and pull the connector apart. We'll open up the center section of the trunk, or lift it up, exposing the spare tire, as well as the battery. Next we'll go ahead and connect our T1 connector in-line, matching up the male and female opposite ends so that you put the T1 connection in-line for the factory harness. more
11/24/2014 4:22:04 PM
