2010 Chevrolet Malibu Custom Fit Vehicle Wiring Installation And Review Videos

Trailer Wiring Harness Installation - 2010 Chevrolet Malibu- Video

Speaker 1: Today on our 2010 Chevrolet Malibu, we're going to be installing the Curt T-connector Vehicle Wiring Harness, part number C56027. This connector is going to give you all of the lighting you need for your trailer through a 4-pole flat connector. It provides you with your left turn signal, right turn signal, taillight, and brake lamps, all the necessary required lights. It has an included dust cap on the end to keep out any dirt and debris and prevent corrosion, and also works kind of nice with your safety chain loops to hold it in place. There's no splicing required. It just plugs right into your existing tail lamp assemblies. more

8/2/2018 1:47:12 PM

Trailer Wiring Harness Installation - 2010 Chevrolet Malibu 118450- Video

Today on this 2010 Chevy Malibu, well be installing the Tow Ready T1 vehicle wiring harness, part number 118450.To start, well need to open up the rear cargo or trunk. Then well go ahead and take the spare tire cover and push it forward, clearing the lip of the rear threshold.Next well pull up on the rear threshold, unlocking it from its mounting position. Next well need to remove the fastener securing the carpeting behind the drivers side taillight assembly. There are two cargo hooks, theyll need to be unscrewed and two pushpin fasteners that will have to pop out here on the drivers side.Then well go ahead and fold the carpeting out of the way exposing the three plastic wing nuts that secure the taillight assembly in place. Well remove these three wing nuts. Now well go ahead and remove the taillight assembly, simply popping it out of position. more

3/15/2013 3:00:36 PM