2008 Chevrolet Equinox Custom Fit Vehicle Wiring Installation And Review Videos

Trailer Wiring Harness Installation - 2008 Chevrolet Equinox- Video

Today on our 2008 Chevrolet Equinox, we'll be installing the T-One Vehicle Wiring Harness for a 4-Pole Flat Trailer Connector, part number 118432. Now when we want to hook up to our trailer, all we have to do is open our jack door here, grab our wiring harness, set it to the side of our hatch latch right here so it doesn't get closed on it, and close our hatch down. Our wiring is in a readily accessible spot right now to hook up to our trailer. We'll take our dust cover off, plug in our trailer wiring and we're good to go. Now when we get to our destination and we've unhooked our trailer, all we have to do is replace our dust cover here, open our hatch back up, tuck our wiring inside the jack compartment, put our jack cover door back in place and it's like our wiring is not even there. It's tucked up out of the way. We don't have to worry about any of our cargo damaging the connector or snagging up on the wires and ripping the wiring out. more

10/19/2016 12:09:42 PM

Trailer Wiring Harness Installation - 2008 Chevrolet Equinox C56012- Video

Rate your transcript OrderClientKevin BrossRef #20676Order #TC0843084131 Today is 2008 Chevrolet Equinox we're going to install part number C56012 from Curt. Okay, to start off we'll go ahead and open the back hatch of the vehicle. Then we need to go to the jack storage compartment. We'll temporarily remove the jack so we can find the port underneath of it. We'll locate the port and then take the wire harness and plug it directly into it. That's all we have to do at the back. Go ahead and re-install the jack and leave the cable out for later. more

8/19/2014 2:48:03 PM