TrailerMate Tail Light Wiring Kit Installation - 2010 Chevrolet Equinox- Video
Today on our 2010 Chevy Equinox we'll be installing the Trailer Mate four pole flat connector for the Trailer Mate custom tail light wiring kits with a powered converter, part number TM85350. This will work in conjunction with the Trailer Mate custom tail light wiring kit for towed vehicles, part number TM780072. To begin our install we'll first need to remove the drivers tail light assembly. We'll go ahead and open up the rear hatch and then the two covers over the two fasteners for the drivers side tail light. Once we have the covers out of the way we'll go ahead and remove the fasteners. Then we'll carefully pop the tail light assembly out of its position being careful not to break the alignment tabs underneath. Then we'll go ahead and disconnect the tail light assemble by pressing on the locking connector that plugs into the back of the socket and sitting the tail light assembly aside. more
1/1/2014 5:49:04 PM
Tekonsha Replacement Breakaway Switch Installation - 2010 Chevrolet Equinox- Video
Today on our 2010 Chevvy Equinox we will be installing the Tekonsha Trailer Breakaway kit, part number 2005-P. We will be adding it here and using our paint marker mark out the attachment point in the bumper beam. We will then go ahead and drill it out and secure it directly to the bumper beam using the hardware provided. Now with our breakaway switch secured, we will go ahead and wrap the wires underneath the vehicle to where we can gain access to them later. Now with the switch installed and wires ran down to the frame, we will move inside the vehicle where we will need to run some extra length of wire to connect to the wires underneath.Next we will need to gain access to the firewall. To gain access to the firewall we will need to remove the dashboard under body panel. more
12/19/2013 4:37:30 AM
