Best 2010 Lincoln MKT Hitch Options- Video
Today on our 2010 Lincoln MKT, we'll be taking a look at the best 3 hitch options available. Up top we're going to have the hidden hitch, part number 87571. Next one down is going to be the Draw-Tite, part number 75679. Finally, down here on the bottom is going to be part number C13110, which is going to be the Curt. All 3 are going to be class 3 hitches, with your 2" by 2" receiver tube openings. The most significant difference between all three of them, since they are very similar in design, is going to be that half inch J-Pin stabilization hole in both your hidden hitch and in the Draw-Tite. All 3 are going to have a black powder coat finish to rid any kind of rust or corrosion as well as be fully welded and constructed. On the front of the Draw-Tite and the hidden hitch, it's going to have a little but more rounded of an aesthetic piece welded onto the end of it, of your 2" by 2" receiver tube. more
10/19/2015 9:20:56 AM
Trailer Hitch Installation - 2010 Lincoln MKT - Hidden Hitch- Video
Today on our 2010 Lincoln MKT, we're going to review and install Hidden Hitch, class 3, two inch receiver tube hitch, part number 87571. Here's what our hitch is going to look like once installed. Our hitch is a nice, stylish round cross tube and a fully welded steel construction with a really nice black powder coated finish. On each side of our receiver tube is going to be our chain hold down and this is our class 3, two inch by two inch receiver tube capable of up to four hundred pounds of tongue weight and four thousand pound tow capacity. Next, I'll give you a couple measurements to assist you with selecting accessories for your new hitch. From the center of the hitch pin hole to the outermost edge of the bumper is six inches. From the top of the receiver tube opening down to the ground is thirteen and a half inches. more
5/14/2015 2:52:30 PM
Trailer Hitch Installation - 2010 Lincoln MKT - Draw-Tite- Video
Speaker: Today on our 2010 Lincoln MKT we're going to review and install the Draw Tie Hitch Part Number 75679. Here's what our hitch is going to look like once it's installed. Our hitch is a nice, stylish round cross tube and a fully-welded steel construction with a really nice black powder coated finish. On each side of our receiver tube is going to be our chain hold down and this is our Class Three Two Inch by Two Inch Receiver Tube capable of up to 400 pounds of tongue weight and 4,000 pound tow capacity. Next, I'll give you a couple of measurements to assist you in selecting accessories for your new hitch. From the hitch-pin hole to the outermost edge of the bumper is six inches. To the top of the receiver tube opening down to the ground is 13 and a half inches. more
5/14/2015 2:52:04 PM
