bing tracking image

2011 Chevrolet Cruze Trailer Hitch Installation And Review Videos

     

Best 2011 Chevrolet Cruze Hitch Options- Video

Best 2011 Chevrolet Cruze Hitch Options

Today we're going to check out the best hitches available for your 2011 Chevrolet Cruze. There's only two so it will be a pretty easy comparison. First off we got our CURT, which is going to be part number C11282, and this one from Draw-Tite, which is going to be part number 24882. Let's go ahead and take a look at one of these that's on the car. In this case this is our CURT hitch. Now both these hitches are going to sit underneath the vehicle and be recessed just like this. They're also going to share the same 1-1/4" opening. more


Watch Video

5/15/2017 1:07:26 PM



Trailer Hitch Installation - 2011 Chevrolet Cruze- Video

Trailer Hitch Installation - 2011 Chevrolet Cruze

Today on this 2011 Chevy Cruze, we are going to be installing Hidden Hitch number 60275. And this installation with also apply to Draw-Tite hitch part number 24859. Before we get started with our hitch installation, we are going to go ahead and give you a couple of the final install dimensions which will make choosing your hitch accessories a little bit easier. From the top of the receiver tube to the ground is going to measure 10 inches and from the center of the pin hole to clear the rear edge of the bumper is going to measure approximately 7 inches. We are going to go ahead and move on to our installation. So up underneath the vehicle now, we go ahead and point out the mounting holes that we are going to be using to attach the hitch to the vehicle. Looking over here on the passenger side frame rail, you can see we have got multiple holes. We are going to be using the rear most hole here and then if you follow forward on the frame, we are going to be using the middle hole as our final attaching point. And that is going to be the same on both the drivers and passenger sides of the vehicle. And here at the forward most hole, this larger hole, we are actually going to be using that as our access point to get our hardware inside the frame. more


Watch Video

12/11/2011 8:42:13 PM



  1