bing tracking image

2013 Chevrolet Silverado Roof Rack Installation And Review Videos

     

Yakima Q Tower Roof Rack Installation - 2013 Chevrolet Silverado- Video

Yakima Q Tower Roof Rack Installation - 2013 Chevrolet Silverado

Today on our 2013 Chevrolet Silverado we'll be test fitting the Yakima Round Bar Roof Rack System using the 58 inch crossbars, part number y00409; the Q118 Q-clips for the Yakima Q-Towers, part number y00718 and the Yakima Q-Towers Roof Rack Feet for the naked roof, part number y00124. With our roof rack assembled according to the instructions we'll begin our test fit by opening both front doors. We'll grab our front bar and place it onto the front part of our roof. To ensure that we have this in the correct location we need to measure 11 inches from the leading edge of the windshield to the closest point on our foot pack. We'll do this measurement for both sides of the vehicle to ensure that our feet are in line with each other. Once we have our front bar in place we can use the thumb screw to tighten down our foot pack. more


Watch Video

8/23/2013 1:22:15 PM



Thule Traverse Roof Rack Installation - 2013 Chevrolet Silverado- Video

Thule Traverse Roof Rack Installation - 2013 Chevrolet Silverado

Today on our 2013 Chevrolet Silverado, well be test fitting the Thule Square Load Bar System using part number THLB58 for the 58 inch load bars, part number TH480 for the Thule Traverse Roof Rack Foot Packs and part number THKIT1532 for the Thule Roof Rack Ticket for the Traverse Foot. With our roof rack assembled according to the instructions, well begin our test fit by grabbing our front bar and place it on to the front part of our roof. To ensure that we have this bar in the correct location, we need to measure 11 inches from the leading edge of the wind shield to the closest point on our foot pack. Well do this measurement for both sides of our vehicle to ensure that our feet are in line with each other. Then we can use the included tool to tighten our clamps in place.Once we have both sides of our front bar tighten down, we can then grab our rear bar and place it on to the rear part of our roof. To ensure that we have this bar in the correct location, we need to measure 31-1/2 inches from the center of our front bar to the center of our second bar. more


Watch Video

8/22/2013 11:15:57 AM



  1