Best 2007 Ford Edge Hitch Options- Video
Today we're going to be taking a look at the best hitch options for your 2007 Ford Edge. Up top we're going to have the CURT class three, part number C13067; followed by the Draw-Tite class three, part number 75992; and finally the CURT class two, part number C12036. The biggest difference that you're going to see between these two hitches is on the Draw-Tite the crosstube here is going to be completely tucked behind the fascia because this receiver tube is welded to the bottom of that, where on both CURT's it's welded in-line with that crosstube so you are going to be able to see some of that crosstube from underneath the rear fascia. On this Draw-Tite it's going to have two pinholes. It's got the standard 5/8" hitch pinhole that's going to be used to secure all the class three accessories. It also has the smaller 1/2" hole which is going to be good for use with a j-pin stabilization system, which helps to eliminate so that shake and play in the shank to help provide a nice quiet, secure ride for your accessories. The class three CURT has this nice large reinforcement plate that's welded onto the top of the crosstube and the top of the receiver tube opening, which helps give it extra stability and durability. Also, when looking at the hitch on the vehicle, that helps give it a little bit cleaner look as well. more
9/30/2016 3:43:52 PM
Trailer Hitch Installation - 2007 Ford Edge- Video
Today in our 2007 Ford Edge we're going to install the hidden hitch part number 87433. Before we can put our hitch in place we need to go ahead and lower the exhaust. Before I lower the exhaust I want to install a safety hanger to support the exhaust after we remove the hangers. Now we have three rubber hangers that we need to remove so that we can lower the exhaust. To remove the rubber hangers it's best to take some spraying lubricant and spray down each one of the hangers first. Now we can take our pry bar push the rubber isolators off the hanger. more
3/20/2012 12:23:14 PM
Trailer Hitch Installation - 2007 Ford Edge 36447- Video
Today on this 2007 Ford Edge we are going to install part number 36447 from Draw-Tite. This also applies to part number 90164 from Hidden Hitch. This is what the hitch looks like on the vehicle and we will give you a couple of measurements that will help you out in ing some accessories such as a bicycle rack, a ball mount, or a cargo carrier. From the top of the receiver opening down to the ground on this particular vehicle is going to be 13-3/ 8 inches. From the center of the hitch pin hole to the outside edge of the bumper is going to be five inches. Next we will show you how it gets installed on the vehicle. 00:34 more
1/19/2011 12:54:26 PM
