Westin Tube Step Installation - 2013 Chevrolet Silverado- Video
Today on our 2013 Chevrolet Silverado 1500, we'll be installing the Westin E-Series Round Nerf Bars that are three inch in diameter, with a polished stainless steel construction, part number 23-1400. It gives you a nice, good, solid entry step to get into your vehicle. It makes it easier to get into the vehicle. This nice, black step pad here gives us a nice, non-slip finish. Even if we have mud on our boots, or it's raining outside, once we step on here we're not going to slip off. It gives us a nice, secure, easy, and safe way to enter our vehicle. There is no drilling required, and it is a quick and easy bolt on installation. Now here's what we have on our driver's side. more
8/7/2016 8:56:30 AM
Bestop PowerBoard Motorized Running Boards Installation - 2013 Chevrolet Silverado- Video
Today on this 2013 Chevy Silverado, we'll be installing the Bestop PowerBoard, part number B7512615. With out powerboards installed, we'll go through the basic operation of our powerboards. With the doors closed, you'll notice that the powerboards are up and our courtesy lights are off. When we open up what is the driver's, passenger's front or rear doors the power board on that side will extend turning on the courtesy light. Then when we close the door, the powerboard will pull back up and tuck back underneath the vehicle. With the power board, it provides a sleek and stylish way to increase the safety and ease of getting in and out of the vehicle. Here's what our powerboard will look like once installed. more
1/19/2015 1:04:13 PM
DeeZee FX Extruded Running Boards Installation - 2013 Chevrolet Silverado- Video
Today on our 2013 Chevrolet Silverado 2500 HD Extended Cab were going to be installing the Dee Zee FX extruded running boards with a black powder coat finish part number DZFX 11352. Weve gone ahead and set the running boards out. Our first step were going to need to install this gasket here on the top lip of the running board. Well go ahead and lineup the end of the gasket with the end of the running board and then well work the gasket under the running board to the other end where we may need to do some trimming.Now that we have our gasket down here on the other end of our running board, youll see that its a little bit longer than the running board. Were going to use a pair of tin snips to cut it the length as we want the gasket to line up with the end of the running board. Ill go ahead and put a quick mark for where we need to cut and we can pull the gasket back up a little bit. more
8/15/2014 9:59:35 AM
