Rhino Rack Roof Rack Review - 2012 Honda Civic- Video
Today on our 2012 Honda Civic, we're going to be test fitting the Rhino Rack Vortex Aero Roof Rack System, consisting of part numbers RRVA126B-2. Those will be their cross bars. Part number RRRLKVA. Those are going to be the legs. Then part number DK319. Those are going to be the clamps that attach it to your vehicle. more
5/27/2016 8:27:16 AM
Yakima Q Tower Roof Rack Installation - 2012 Honda Civic- Video
Today on our 2012 Honda Civic Sedan, well be test fitting the Yakima Round Bar Roof Racking System, part numbers Y00409, Y00699, Y00731 and Y00124. With our roof rack already assembled according to the instructions, well begin our test fit by placing the front crossbar onto the front of the vehicle. Well measure seven inches from the front part of the glass to the first part of the tower on the front crossbar.Well do this on both the passenger and the driver side of the vehicle ensuring that crossbar is perpendicular to the vehicle. Once we have established this measurement, well tighten down the bolts inside of the que towers and clamp down the front black plastic cap securing the crossbar to the front of the vehicle. Well now place the rear crossbar on the rear of the vehicle and well measure the crossbar spread. This is the measurement from the center of the front crossbar to the center of the rear crossbar. more
3/26/2013 2:02:43 PM
Thule Traverse Roof Rack Installation - 2012 Honda Civic- Video
Today on our 2012 Honda Civic, well be test fitting a Thule Roof Rack System. We will be using the 58 square load bars, part number THLB58, the Traverse foot pack, and part number TH480, as well as the fit kit for our Civic which is part number THKIT1425. We already have our load bars assembled according to the instructions, so now we are ready to mount them up on our vehicle. First we will need to open up the driver and passenger front doors, well set the front load bar assembly up on top of our roof and to position it correctly well measure 10-5/8 from the edge of the windshield to the leading edge of the Traverse foot, we will make sure these measurements are the same on both sides, so then we will use the included Accutite tools to tighten the feed to our vehicle. Now we can put on our rear load bar. Again we will open the rear passenger and driver doors and set the bar up on top of the roof. more
9/7/2012 4:56:06 AM
