Yakima Roof Rack Review - 2013 Chevrolet Cruze- Video
Speaker 1: Today on our 2013 Chevrolet Cruise, we're going to be doing a test fit of our Yakima Jet Stream roof rack system. That's going to consist of our 50 inch black Yakima Jet Stream crossbars and that's part number Y00425. They also come in silver, which is part number Y00428. It's also going to consist of our baseline towers, part number Y00146 and our base clip fit kits, part numbers Y06137 and Y06127.This Yakima roof rack system is going to allow you to carry many different types of roof mounted accessories, such as bike racks or cargo boxes. They feature and aerodynamic design, which is going to make them far quieter than our traditional round or square bars.It's going to work with your clamp on accessories. It's also going to accommodate your T squad accessories. more
11/16/2018 2:37:14 PM
Rhino-Rack Aero Roof Rack Installation - 2013 Chevrolet Cruze- Video
Speaker: Today on our 2013 Chevy Cruze, well be test fitting the Rhino-Rack roof rack system using part numbers DA126B and DK142. We will begin our test fit by placing the front bar onto the front of our roof. Well measure from the center of the doorjamb to the center of the front bar 13 and 3/8 inches. Well make this measurement on both the passenger and driver side of the vehicle to ensure the front bar is perpendicular to the roof of our crews. With the front bar in place, we can then use the included tightening tool to bring the clips up tightly against the roof line. Now you will need the alternate sides when tightening it down, so one side of the bar doesnt favor one side of the vehicle.With the front bar in place, well place the rear bar onto our roof. more
10/23/2013 10:11:06 AM
SportRack Semi-Custom Roof Rack Review - 2013 Chevrolet Cruze- Video
Today on our 2013 Chevrolet Cruz we'll be test fitting the Sportrack Semi-Custom Roof Rack for naked roofs, fifty inches in length, part number SR1010. We'll begin our test fit by placing the front bar onto the front of our roof. We'll then need to measure, according to the fit guide, seven inches from the center of the door jamb to the first part of the foot. We'll make this measurement on both the driver's side and passenger's side of the vehicle to ensure the front bar is correctly in place. We can use the included allen wrench to loosen up the allen bolts to fit the brackets around the roof line. With the clamps in place, we can then again use the included allen wrench to tighten down the clips up against the roof line. Quick tech tip: You'll need to alternate sides when tightening it down so the bar doesn't favor one side of the vehicle. With the front bar in place, we can now place the rear bar onto the rear of our roof and measure the load bar spread. Now the load bar spread is the measurement from the center of the front load bar to the center of the rear load bar. We'll measure twenty-four inches from the center of the front bar to the center of the rear bar on both the passenger and driver's side of the vehicle. This will ensure that both bars are parallel to each other and perpendicular to the roof of our Cruz. more
9/12/2013 9:21:04 AM
