bing tracking image

2010 Ford Escape Ski and Snowboard Racks Installation And Review Videos

     

Yakima FatCat Ski and Snowboard Carrier Review - 2010 Ford Escape- Video

Yakima FatCat Ski and Snowboard Carrier Review - 2010 Ford Escape

Today on our 2010 Ford Escape we'll be test fitting the Yakima FatCat 6 locking rooftop ski and snowboard carrier with a 6-ski or 4-board capacity, part number Y03088. With a factory roof rack system on our Escape we'll begin our test fit by placing the front part of the carrier onto our front crossbar. We'll bring the rubber-coated steel straps around the underside of the bar and hook them into the connection points. Now you may need to turn the red knob on the inside of the top bracket to tighten the strap. Tighten down the black lever and clamp it down, which will secure the connection piece in place. We'll then move to the other side of the vehicle and repeat the same process. With the front part of the carrier secured, we're ready to install the back part of the carrier. We'll just repeat the same installation process as we did with the front. more


Watch Video

10/10/2014 8:38:40 AM



Whispbar Roof Ski and Snowboard Carrier Review - 2010 Ford Escape- Video

Whispbar Roof Ski and Snowboard Carrier Review - 2010 Ford Escape

Today on our 2010 Ford Escape we'll be test fitting the Whispbar locking rooftop ski and snowboard carrier with a 6-ski or 4-board capacity, part number WB-300. With a factory roof rack on our Escape we'll begin our test fit by placing the front part of the carrier onto our front crossbar. We'll swing the rubber-coated steel straps around the underside of the bar and hook them into the connection points. With it in place, we'll need to open up the jaws of the carrier by pushing into the black over-sized button. We'll need to make sure the lever is up and loose. We will then tighten down the black lever and clamp it down, which will secure that connection piece. After repeating the same process for the other side we'll place the rear part of the carrier onto the rear bar and repeat the same installation process. Now that both pieces of the carrier are installed, we're ready to load up our skis and our snowboard. We'll need to push in the black over-sized button at the end of the carrier and open up the jaws. more


Watch Video

10/10/2014 8:38:29 AM



  1