bing tracking image

2013 Honda Fit Trailer Hitch Installation And Review Videos

     

Trailer Hitch Installation - 2013 Honda Fit - Draw-Tite- Video

Trailer Hitch Installation - 2013 Honda Fit - Draw-Tite

Speaker 1: Today on our 2013 Honda Fit, we're gonna be installing the draw tight support frame trailer hitch, part number 24826.So with our hitch installed, this is what it's gonna look like. It's a smaller hitch, so it hides well. But it is gonna be below the vehicle, and it is gonna be noticeable. It has a square tube design that's gonna be rigid, and also look nice. It's custom designed for your Honda Fit. It's gonna curve right around your exhaust, and bolt right up without any drilling or welding required.It's a Class 1 hitch with a 1 and 1/4 inch receiving tube. more


Watch Video

7/30/2018 3:52:51 PM



Best 2013 Honda Fit Hitch Options- Video

Best 2013 Honda Fit Hitch Options

Today we're going to be taking a look at the best hitch options for the 2013 Honda Fit. Our most popular is going to be the Draw-Tite Class 1. That part number is 24826. We'll follow that up with the Curt Class 1, part number C11064. Now you can see there's quite a bit of a difference here in the design of our hitches overall. The Curt has a couple of arms that are going to come up on each side to a single connection point, then there's a plate that's going to run underneath the vehicle and it offers two more connection points underneath the spare tire well in the back of the car. Now the Draw-Tite is going to use already existing holes. more


Watch Video

1/25/2017 10:25:31 AM



Trailer Hitch Installation - 2013 Honda Fit - Curt- Video

Trailer Hitch Installation - 2013 Honda Fit - Curt

Today, on our 2013 Honda Fit, we're going to install part number C11064 from Curt. This is what the hitch looks like once it's installed on a Honda Fit. Next, we'll use some measurements to help you out in selecting some accessories such as a bicycle rack or a cargo carrier. On top of receiver opening down to the ground is 9-3/4 inches and we set out hitch pinhole to the edge of the bumper is about 3-3/4 inches. Now, we'll go ahead and show you how the hitch is installed. First thing you need to do is get the vehicle ready to install the hitch. more


Watch Video

6/12/2014 1:20:22 PM



  1