Best 2007 Chevrolet Impala Custom Fit Vehicle Wiring Options- Video
Rob: Rob here at etrailer.com, and today you're going to be taking a look at the best trailer wiring options for your 2006 through 2013 Chevrolet Impala. Here we're going to have our CURT wiring, which is going to give us a four-pole flat trailer connector. Then over here we're going to have our Tekonsha wiring, which is also going to give us a four-pole flat trailer connector.Now if I was looking for wiring for my Impala, I personally would go with the CURT because a few little things that they give you that the Tekonsha doesn't in the packaging. Let's take a closer look at some of the features of both of them.Since both of our kits are going to give us that four-pole flat trailer connector, it's going to give us all the required lights to get down the road safely, like our taillights, turn signals, and our brake lights. As far as installation goes, it is going to be custom fit, so we're not going to have to worry about cutting or splicing with either one of our wiring kits. We're just going to have a simple T-connector that's going to plug inline behind our passenger side taillight.Now CURT's going to use the same T-style connector to plug in behind the passenger taillight, but they're going to provide you with some black silicone because there's a rubber grommet that we can cut a slit in, pass our wires through, and then our wiring is going to stay inside the trunk until we need it, whereas the Tekonsha is designed to stay on the outside. more
3/28/2019 12:57:15 PM
Trailer Wiring Harness Installation - 2007 Chevrolet Impala- Video
Today we are going to install part number 118417 from Tow Ready. We are going to install this on a 2007 Chevrolet Impala. To install the T-1 connector, we have to get back behind the tail light assembly here and behind this plastic. We are also going to be taking off the passengers side tail light, too. And this whole panel will just pop up straight vertical. And we are going to take off this other wing nut right here. Now that we have got our tail light loose, we are going to just temporarily disconnect it from the wiring harness. And then this actual plug right here is where our T-1 connector is going to hook up to the vehicle. We will reconnect the T-1 connector back in, and just tuck that back between the bumper fascia and the body. And we are also going to take our 4-pole wire, and we are going to route that straight down, because that is going to come out by the hitch itself. Make sure to leave that ground wire, because we are going to attach it to the sheet metal below the tail light. And we will just clip our original wire harness back on. more
4/7/2009 10:15:48 AM
