Trailer Hitch Installation - 2011 Kia Sedona - Curt- Video
Today on a 2011 Kia Sedona we are going to review and install the Curt class 3, 2 inch receiver hitch, part number C13345. Now here is what it's going to look like once it is installed. As you can see just below the rear fascia is our completely steel round cross tube, and fully welded constructed hitch. The hitch itself has a nice black powder coated finish to resist rust and corrosion, and the cross tube will lead to our chain hold down on each side. By the spin roll that goes through our receiver tube and our class 3, 2 inch by 2 inch receiver tube. The hitch itself is capable of up to 350 lbs of tongue weight and a 3500 lbs tow capacity. Next, we will give you a couple measurements. This will assist you select accessories such as a ball mount, bike rack, or cargo carrier. From the center of the hitch pin hold to the outer most edge of the bumper is approximately 6 inches. From the top of the receiver tube opening down to the ground, is approximately 12 inches. Next, we will go ahead and show you the minimum tools required for installing the hitch. We are going to use our 1/2 inch tube brush and a spray lubricant, 3/4 inch socket, using extension, ratchet, and then our torque wrench. Now let's go ahead and show you just how easy it is to install the hitch. Now that we did our install, let's go ahead and point out the attachment points. Now we are going to have a total of 6 attachment points, 3 on each side. more
7/29/2015 12:01:36 PM
Trailer Hitch Installation - 2011 Kia Sedona - Draw-Tite- Video
Today, on our 2011 Kia Sedona, we're going to review an install. The Draw Tie Hitch, part number 75421. Here's what our hitch is going to look like once installed. The majority of our hitch is exposed underneath the lower fascia and body of the vehicle. Its got a nice stylish round cross tube, and it's a completely steel and fully welded construction. The entire hitch has a nice black powder coated finish to resist rust and corrosion over time. Here, at the receiver tube, we've got our half inch pin hole. more
7/29/2015 12:01:20 PM
Trailer Hitch Installation - 2011 Kia Sedona - Hidden Hitch- Video
Today on our 2011 Kia Sedona we are going to review and install the hidden hitch, class 3, 2 inch receiver tube hitch, part #70761. Here's what our hitch is going to look like once installed. The majority of our hitch is exposed underneath the lower fascia and body of the vehicle. It's got a nice stylish round cross tube, and it's a completely steel and fully welded construction. The entire hitch has a nice black powder coated finish to resist rust and corrosion over time. Here at the receiver tube we've got our 1/2 inch pin hole. Additionally, we have a 1/2 inch pre-drilled hole for the J-pin anti-rattle bolt. more
7/29/2015 12:01:06 PM
