Trailer Wiring Harness Installation - 2013 Toyota Venza- Video
Today on our 2013 Toyota Venza, we'll be installing the Curt T-One vehicle wiring harness with 4-pole flat connector, part number C56079. Now we can go ahead and show you how to use the new 4-pole connector. Simply raise the rear cargo mat and cover, take the 4-pole and run it out and down to the center of the vehicle to your hitch or accessory, be careful to stay away from the latch as pinching the wire off in the latch can damage it, however the weatherstripping is thick enough it won't and we can simple close the rear tailgate on it. Then once we're finished using our new 4-pole connector, we'll simply roll it up and store it down next to the spare tire. To begin our install, we'll first open up the rear tailgate and then remove the rear cargo cover. Next we'll remove the rear floor panels, we have the center panel and two corners. Next we'll remove the cargo trays, there's one on each side. more
10/15/2014 12:28:15 PM
