Trailer Hitch Installation - 2010 Cadillac SRX - Draw-Tite- Video
Narrator: Today on our 2010 Cadillac SRX, we're going to be taking a look at and showing you how to install the Draw-Tite Class Three Custom Fit Trailer Receiver, part number 75682.So, here's where our hitch looks like fully installed. It is going to tuck up behind our bumper, but we are going to have a slight bit of the cross tube sticking out right here. Now it is a Class Three, which means it's going to give us that two inch by two inch receiver tube opening, and as you can see, it has a rainforest collar, not only getting added strength, but a nice clean, finished look.Our hitch is going to use a standard five ace pinning clip, and that's that's going to be the hole towards the front of the vehicle. The pinning clip aren't included, but you can pick one up on our website using part number PC3. Now, the second hole towards the back of our receiver, that's going to be for the J-Pin Stabilization Device. That's going to be great if any of your accessories don't have a built in anti-rattle.As far as the safety chain connections, it's going to be a plate-style welded to the bottom, and as you can see, we're not going to have any trouble getting most sized hooks on or off. more
7/31/2017 10:47:50 AM
Best 2010 Cadillac SRX Hitch Options- Video
Today we're going to be taking a look at the best hitch options for you 2010 Cadillac SRX. We're going to start with our top hitch here. This is the going to be the Curt Class 3 part number C13002. Our second hitch is going to be the Curt Class 2 hitch, part number C12070. Followed by the last one here, a Draw Tite class 3, part number 75682. Our first major difference in our hitch is going to be this Curt here. This is going to be a class 2 hitch where the other ones are going to be class 3s. more
6/29/2016 12:29:02 PM
Trailer Hitch Installation - 2010 Cadillac SRX - Curt- Video
Today we have our 2010 Cadillac SRX. We are installing our Curt Custom Fit Trailer Hitch Class 3, part number C13002. Now, we'll give you some measurements to help you out with picking your ball mount, bike rack, or cargo carrier. From the center of your hitch pin hole to the outermost part of your bumper is three and a half inches. From the top of your receiver to the ground is eighteen and three quarter inches. To start out we need to find our factory wiring harness which is installed on our bumper, so we'll go ahead and take these two phillips screws off. more
11/13/2015 12:04:35 PM
