2014 Ram 2500 Accessories and Parts Installation And Review Videos

Superwinch 4-Circuit Breaker Installation - 2014 Ram 2500- Video

Today on our 2014 RAM Pickup Truck 2500 series we're going to be installing a super wench replacement 4 circuit breaker with bracket, part number SW90-22147, on a vehicle that has a super wench Talon series off road wench part number Sw1612210. We'll first begin here by raising up the hood. Now over here on the driver side battery, you can see here, this is where they already have the wench wiring connected to the positive side of the battery. So, we'll need to first disconnect that, and then we'll add our new circuit breaker inline. Go ahead and disconnect that for now. Go ahead and put this back on for now. Here's the circuit breaker that we're going to be installing today. more

9/5/2014 2:28:02 PM

Superwinch Front Mount Electric Winch Wiring Installation - 2014 Ram 2500- Video

Today on our 2014 Ram Pickup, we'll be installing the Super Winch front vehicle electric winch wiring harness, part number SW2007. We'll begin here on the winch. We're going to need to remove the cover that covers up the center cylinoid section. We'll need to remove these four Allen head bolts right here up underneath the cover. Once these are done, we'll need to remove two more Allen head bolts here on the end, as well as five Phillips head screws up underneath. That will allow us to remove the cover and gain access to the bolt that holds the red wire, or the positive wire on the cylinoid side. more

5/27/2014 5:35:10 AM

Convert-A-Ball Cushioned Weight Distribution Shank Review - 2014 Ram 2500- Video

Today on our 2014 Ram 2500, we'll be test fitting the Convert-A-Ball cushioned weight distribution shank for 2-inch hitches rated at 10,000 pounds, part number AMAC1. Now, our vehicle is equipped with a 2-1/2-inch hitch, so we'll be using the Blue Ox Hitch Reducer Sleeve from a 2-1/2-inch to a 2-inch hitch, part number BX88187. Before we begin our test fit, we'll need to get the hitch height of our pickup truck. With the adapter already inserted into the hitch, we have about a 24-inch hitch height. Keep in mind, this measurement may vary due to the tire size, hitch style, or after-market accessories. We'll start off our test fit in the drop position by sliding the shank of the weight distribution into the opening of our sleeve. We'll line up the 2 pin holes and then continue to slide the sleeve back into the hitch. We'll then insert the pin through the pin holes and then secure it with the clip on the other side. Now, there's a total of 7 holes on this weight distribution shank. more

3/27/2014 10:18:13 AM