Trailer Wiring Harness Installation - 2004 Ford Mustang- Video
Today, on our 2004 Ford Mustang, we'll be installing the tow ready T1 connector trailer wiring, part number 118326. To begin with, we'll need to raise the trunk lid on the vehicle. Then we'll need to remove 2 plastic nuts, one on each side, just behind where the tail lights are. With this plastic nut removed, we can go ahead and pull back the inner trunk liner, exposing the wiring that we'll be connecting with. Now, on the driver's side, we'll be connecting with the side that has the yellow wire in the bundle. We'll go ahead and disconnect the wiring here, and put our T-connection in place. Make sure when you pull apart the clips that you do not pull too hard, because they can break very easily. Now, on this side, we'll need to go ahead and connect our ground wire. To do this, we use a self tapping screw, and we'll find an area of sheet metal that's been doubled up. We want to make sure that there's nothing behind the sheet metal that could be damaged. Then, the green wire with the other 2 connectors will be routed all the way over to the passenger side. We can work the wires underneath the rear trunk lining piece, just right here by the threshold area. Then we'll access the wiring connection over here. We'll repeat the same process as we did on the driver's side, except on this side there will not be a ground wire that we will install. Now, with the connections made, we'll go ahead and put the interior trim back in. more
7/3/2014 10:21:43 AM
