Trailer Wiring Harness Installation - 2013 Toyota Sienna- Video
Today we're going to be taking a look at and installing the T-One 4-pole flat trailer connector and wiring harness for the 2013 Toyota Sienna, part number 118498. Right now we're going to take a look at the wiring as you pull it out of the package, so that way you'll understand where each wire goes, and how it all comes together. The yellow wire with the white on it will go to the driver's side. The red, brown, and the green with the four ends on it is going to go to the passenger's side. You will have your ground wire in the center, your power wire, the 12 volt that you will use with the black wire here, connecting it with the butt connector and taking it up to the front of the vehicle. We'll explain that here in a second. more
7/27/2015 8:07:26 AM
Trailer Wiring Harness Installation - 2013 Toyota Sienna C56106- Video
Today on our 2013 Toyota Sienna well be installing the Curt T-Connector Vehicle Wiring Harness with Four-Pole Flat Trailer Connector, part number C56106. Now when you need to use your four flat for towing youll simply pull it out of the storage area, set it here across the rear threshold area, keeping it away from the center latch mechanism as it can damage the wire. Well then go ahead and close the rear hatch. Now when youre done towing you simply raise the rear hatch. When youre not using your four flat its a good idea to put the wire out of the way into a storage area to keep it from being damaged. Well first begin by raising the rear hatch of the vehicle. Next well need to remove both taillight assemblies by removing the two screws located here inside the hatch area. Next were going to need to slide the taillight assembly out. more
7/22/2014 1:18:31 PM
