Best 2014 Nissan Rogue Trailer Wiring Options- Video
Today we're going to be taking a look at the best wiring options for your 2014 Nissan Rogue. Here we have the CURT T-Connector vehicle wiring harness. Over here we have the Tekonsha T-One vehicle wiring harness. Now both of them are going to give us the same end result. They're going to give us a four-pole flat and the ability to have lights on our trailer. Now both of our kits are going to live inside of our vehicle until we're ready to tow. When we are, we can simply drop our lead down and close our hatch. more
5/24/2017 9:54:01 AM
Trailer Wiring Harness Installation - 2014 Nissan Rogue- Video
Today, on this 2014 Nissan Rogue, we're going to show you the T-One vehicle wiring harness with a 4-pole flat trailer connector, part number 118480. This is from Tow Ready. Now, when we do need to use it, pull it off to the side so we stay away from the latch in the center so it doesn't damage the wire. Route it down to our hitch. We can go ahead and shut the hatch on it. The door seal's thick enough where it won't hurt anything. more
9/22/2015 3:46:34 PM
Trailer Wiring Harness Installation - 2014 Nissan Rogue Select C56033- Video
Today on our 2014 Nissan Rogue Select, we'll be installing the Curt T-connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number C56033. Now to begin the install, we'll open up the rear hatch and we'll need to remove the interior paneling until we can access the wiring behind the taillight assembly. To start, we're going to go ahead and take the spare tire cover and flip it up out of the way. Then remove the spare tire storage compartment. We'll unlock both sides and pick it up and set it aside. Next we'll remove the carpet of paneling on each corner. more
1/22/2015 7:50:15 AM
Trailer Wiring Harness Installation - 2014 Nissan Rogue C56033- Video
Today on our 2014 Nissan Rogue, we're going to install Part #C56033 from Curt. Before we install our wire harness, we need to get our vehicle ready. To do that we need to loosen up some interior panels to get access to the wiring which will be behind the taillights on the interior of the body. So to start off we'll go ahead and remove our floor coverings to get down to the spare tire area. Next, we'll go ahead and remove our threshold. There'll be a plastic rivet on each side that we have to remove. more
3/3/2014 9:40:44 AM
