Best 2013 Jeep Grand Cherokee Trailer Wiring Options- Video
Today on our 2013 Jeep Grand Cherokee we'll be looking at our best trailer wiring options. All right, we have two wiring harnesses here today. Both of these provide us with a four-pole flat trailer connector. Right here we have the Tekonsha T-One vehicle wiring harness, part number 118425. Now over here we have the CURT T-Connector, part number C56009. The biggest difference that we found between our two wiring harnesses here, besides the fact that they come from different brands, is our dust covers. Our dust cover on the Tekonsha is molded into the end of our four-pole flat here so you don't have to worry about it falling off, whereas on our CURT here, it's a separate piece that slides over the end of your connector here, down the wire a little bit, and then folds back over. more
2/13/2017 4:27:49 PM
Trailer Wiring Harness Installation - 2013 Jeep Grand Cherokee- Video
Today on our 2013 Jeep Grand Cherokee, we're going to review and install the Curt Custom Vehicle Wiring Trailer Connector, part number C56009. Now to begin our install, we're first going to open up the rear hatch. We need to remove both rear tail light assemblies. Each tail light assembly is secured with two fasteners. These are pushpin fasteners, so we're going to pry the center of the fastener out, and then remove it completely. Just using a flat blade screwdriver, we can get underneath that center, just work it out. Note, if you have an interior trim panel tool, it can help to get underneath the head of the fastener, prying it out. Once you have it pried out, you can remove the whole fastener. more
5/4/2015 3:30:35 PM
Trailer Wiring Harness Installation - 2013 Jeep Grand Cherokee 118425- Video
Today on our 2013 Jeep Grand Cherokee we're going to review and install the Tow Ready T-One Vehicle Wiring Harness with 4-pole flat trailer connector, part number 118425. Now to begin our install we're first going to open up the rear hatch. We need to remove both rear taillight assemblies. Each taillight assembly is secured with two fasteners. These are push pin fasteners so we're going to pry the center of the fastener out and then remove it completely. Just using a flat-bladed screwdriver, we get underneath that center, just work it out. more
5/1/2015 10:51:06 AM