bing tracking image

1999 Ford F-250 and F-350 Super Duty Accessories and Parts Installation And Review Videos

     

Trailer Brake Controller Installation - 1999 Ford F-350 Super Duty- Video

Trailer Brake Controller Installation - 1999 Ford F-350 Super Duty

Today in our 1999 Ford F350 Super Duty, well be installing the Tekonsha Prodigy P3 Brake Controller with the direct fit wiring harness part number 90195 in conjunction with 3035-P. To begin our install, well first need to locate the manufacturers tow port. This will be underneath the kick panel below the steering wheel. Well go ahead and remove the four fasteners that secure the kick panel and then pull it down and out of the way. To remove the kick panel or knee bolster here, well just rotate the screw heads so that they pop out. . more


Watch Video

9/9/2014 11:58:27 AM



Fifth Wheel Installation - 1999 Ford F-350- Video

Fifth Wheel Installation - 1999 Ford F-350

Today on this 1999 Ford F-350 super duty, we are going to install part number RP50082. The first thing we need to do is go ahead and lower the spare tire so we have access underneath the vehicle. And then once we have that done, we will go into the bed of the truck and we will start marking out the places for our rails. What we are going to do is measure out from the edge of the bed itself, not the tailgate but the bed, and we are going to measure out and place a mark in the bed as described in the instructions. We are going to do that in two places on both sides. Now we have our mounts in our bed. We will line up our first rail and you are going to want to get them even left to right, using the seam right here works out pretty good. Our custom install kit on the bottom is going to use these two outside holes here. So we will find the center and mark that. Do that on both sides of the rail. Alright, let us move our rail out of the way. We will go ahead and drill a couple 1/8 inch holes. Now we are by the frame of the vehicle on the driver side. Now you do not want to really have to take off the back tires but we did anyway for clarity. One thing we know is that our plate is going to have to sit flat on the frame so that our brake cable here is going to be in the way. So, we are going to move that out of the way. There will be a provision to but that back on later on. 1:12 more


Watch Video

9/30/2010 6:03:15 AM



  1