Trailer Hitch Installation - 2010 Mazda 3 - Draw-Tite Video

The Curt Trailer Hitch Receiver #C11393 will not contact the exhaust on your 2012 Mazda 3 sedan.

The Swagman XTC 4 bike rack you currently have is not compatible with the Class I receiver like the Curt #C11393, which is the only receiver available for the 2010 Mazda 3. Due to the size of the vehicle, as well as the rigidity of the area where the…

For a carbon frame bike a hitch bike rack that holds the bike by just the tires is the only safe option. Trunk racks all touch the frame which is something you need to avoid with carbon frame bikes. So for a hitch you'd need the Draw Tite #24843…

The Draw-Tite Sportframe Trailer Hitch Receiver you referenced, part #24816, fits the Mazda 3 up through model year 2009, but I can tell you the correct hitch fit for your 2012 Mazda 3 as well. You can use the link provided to see our main page for…

The Curt Trailer Hitch, #11383, is designed to fit the 2010 and 2011 Mazda 3 Hatchback but not the sedan. I have included a link to the trailer hitches available for the Sedan, Non-Grand Touring model for you to view. The equivalent hitch for your 4…

There are specific fits for a 2010 Mazda 3 for the hatchback vs. the sedan. If you have a sedan, I recommend the Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" #C11393. If you have a hatchback, I recommend the Draw-Tite Sportframe…

On both the Hidden Hitch 60258 (discontinued) and the Draw-Tite, #24843, the top of the receiver tube will be approximately 1 inch below the bottom of the rear fascia. The bottom of the receiver will then be another 1-3/4 inches below that. Measure…

When you test the 4-Way on the Curt T-Connector Wiring Harness, part #56016, at the rear of your vehicle, it should show now power on all 3 pins with the lights off. If you have the vehicle head lights on, you should have around 12 volts at the brown…

The Curt T-Connector Vehicle Wiring Harness part #C56011 is indeed the correct wiring harness for your 2015 Honda Accord without LED tail lights. The issue you are describing sounds like a ground issue. Please make sure that the ground you are using…

The provisions of the Curt Class I #C11393 hitch warranty requires the use of a stabilizing strap like part #18050 for non-trailer loads like a cargo carrier or bike rack. Keep in mind, the hitch manufacturers punch a stop into the receiver tube of a…

Draw-Tite Class I hitch #24816 fits several model years of the Mazda 3 and it has a maximum trailer weight capacity of 2000-lbs, along with a maximum tongue weight rating of 200-lbs. If your loaded trailer weighs less than 2000-lbs and places no more…

The Curt Class I Receiver Hitch, #11393, for the 2010 Mazda 3 will fit on either model, with or without LED tail lights. The note you are seeing about LED lights pertains to the wiring for the Mazda 3 because a different trailer wiring harness is…