Trailer Brake Controller Installation - 2014 Dodge Grand Caravan Video

The Tekonsha Prodigy P3 Trailer Brake Controller #90195 can be mounted anywhere on, in, or below your dash so long as it is horizontally level and parallel with the direction of travel. You will be able to use the Tekonsha Custom Wiring Adapter for…

Anytime the fully loaded and ready to tow trailer weight is greater than 50 percent of the weight of the tow vehicle, using weight distribution should be considered. When you get the pop-up, hitch it to the vehicle and pay special attention to the…

You will need to use a standard weight distribution kit like the Heavy Duty Trunnion Weight Distribution System #RP66131 for your I-beam trailer. This system would be rated perfectly for your 10k trailer if it was going to be loaded near it's…

You are correct that the welded plate on your trailer frame will obstruct the installation of most weight distribution brackets. The best solution for your case is to use these Chain Hangers #RP58305. These bolt on to the side of your trailer frame…

You can certainly add a 7-way trailer connector to your trailer with 6 wires. You would simply have 1 pin on the 7-way connector that did not function. I recommend adding a 7-way molded trailer wire connector like part #H20046, and a junction box…

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

Trailer frame weld nuts notoriously end up with rust in them which makes installing hitch hardware pretty difficult. Often times it seems like the solution is to use smaller hitch hardware but the real solution is to clean out the weld nuts so that…

When you are looking for the stoplight switch wire, start at the brake pedal and work upward. You will see a cluster of wires very near the pedal that will contain the brake light switch wire. On the 2010 Grand Caravan model we wired for a P2 brake…

If you already have a 7-way trailer connector on the rear of your 2012 Dodge Grand Caravan then all you will need to install a brake controller is the brake output wire (usually blue) that runs from the 7-way to the brake controller and the 12 volt…

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

The control knob of the Redarc Tow Pro Liberty part #RED24FR does light up based on connection status and what is doing but it does not light up in a different way when the headlights come on. But since the knob will be lit up at all times you'll…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…