Front Mount Trailer Hitch Installation - 2012 Ram 3500 - Draw-Tite Video

Thank you for your photo showing the portion of Draw-Tite front-mount hitch #65063 for which you are looking for a measured dimension to allow planning of light bar installation. I went to our warehouse and measured the length of the hitch tubing…

For your 2018 Ram 2500 we have two front hitches that are confirmed as a fit. We have the Draw Tite part #65063 which has the hitch opening much higher as it comes out of the lower bumper or we have the Curt part #C31015 which has the hitch opening…

Though the front mount hitch #EH37FR is not confirmed to fit your 2021 Ram 5500 The Curt Class V Universal Weld-on Receiver Hitch #15902 can be fabricated to fit the front of your 2021 Ram 5500. The hitch has a black powder coat finish that will…

The Curt Front Mount Trailer Hitch Receiver #31320 will provide better ground clearance for your 2005 Dodge Ram 1500 by approximately 3 inches. I have attached a photo that will show you the measurements from the mounting surface of each hitch to the…

The Draw-Tite #65046 front mounted receiver will fit the 2004 Dodge Ram 3500. When the hitch is installed, the receiver tube will butt up against the underside of the front bumper fascia, a few inches below the license plate, as you'll see in the…

The HappiJac Swing-Out Extender Bracket #HJ54FR that you referenced is sold individually.

The front mount trailer hitch I recommend for a 2012 Ram 3500 4x4 is the Draw-Tite Front Mount Trailer Hitch Receiver part #65063 which requires the least amount of modifications and also has the cleanest install look but does require that you have…

The Draw-Tite Trailer Hitch 76194 fits a 2016-2023 Volvo XC90 it will not fit a 2018 Volvo V90. I confirmed this information with Draw-Tite and our own installation guide. The crossbar is required to hang down a few inches below for the XC90 than it…

The etrailer Hitch Mounted Spare Tire Carrier part #e98ZR works with any spare wheel/tire with bolt pattern up to 6 on 5-1/2", so 5 on 4-1/2" and 4 on 4" are all good as well. The tire size doesn't really matter, it's about the…

RV bumpers that are square with all for sides continuously welded are technically a part of the trailer's chassis and can carry a decent amount of weight. Installing the Swagman Around the Spare part #S80501 with your spare would not be an issue…

For your older Snowbear plow we have confirmed with them that the correct kit to convert it to fit a 2 inch hitch is the part #SB324-120 that you referenced. Then for a hitch for your 2015 Ram Big Horn you'd want the Curt #C31067 and you'd be…

I can definitely help you out with the measurements you are needing. I went out to our warehouse to take a look at the Draw-Tite Front Mount Hitch Receiver #65063 that you referenced. This hitch features an overall width of 43-1/2 inches. From the…