Curt Trailer Hitch Installation - 2020 Toyota RAV4 Video

My recommendation for your 2020 Toyota RAV-4 XSE Hybrid is the Curt Trailer Hitch Receiver #C13416. The Curt is the simplest of the options available to install and provides sufficient capacity for towing uses. The RAV-4 is limited on towing…

The best hitch for your 2024 Toyota RAV4 is the etrailer Trailer Hitch Receiver #e23ZR. This custom-fit Class III hitch has a 2" receiver and a bolt-on installation. It also has a concealed cross-tube so only the receiver will be visible…

Installing a hitch on your 2020 Toyota RAV4 like the Curt you referenced part #C13416 will still allow the hands free lift gate to function but you'd need to just kick to either side of the hitch opening. I attached an install video for this…

The best looking hitch for your 2024 Toyota RAV4 Hybrid is the etrailer Trailer Hitch Receiver #e23ZR. This is a Class III hitch with a 2" receiver and a bolt-on installation. It has a concealed cross tube so only the receiver will be visible at…

The best trailer hitch receiver for carrying bikes that fits your 2021 Toyota RAV4 Limited Hybrid is the EcoHitch Hidden Trailer Hitch Receiver #EH97FR. The reason for that is because it has the best ground and bumper clearance for a bike rack…

Rust resistance is going to be the same for all of the hitches listed for your 2022 Toyota RAV4 since they all have the same standard of powder coating used for protection. I recommend going with the etrailer Trailer Hitch Receiver #e23ZR simply…

If you check out the install picture I attached for the Curt hitch part #C13416 you can see that it hangs at the same height as the exhaust pipes and only sticks out a little bit past them so you'd have the same ground clearance you have now. Or…

Extending the black power wire to the battery of the 2020 Toyota RAV4 from the Curt T-Connector part #C56434 can be done in a couple of ways. You can route the wire through the frame under the vehicle or route the wire through the vehicle itself. The…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

Yes, the Draw-Tite Ball Mount part #DT49MR comes with a pre-torqued 2" hitch ball as well as a 5/8" diameter hitch pin and clip. It comes ready to go and use.

I'd recommend going with the Curt #C56434, which would install as shown in the video I've linked for you. The Curt harness is rated for more amperage than the Tekonsha model, which I why I recommend it.

The etrailer Trailer Hitch Receiver #e23ZR does not require lowering/dropping the exhaust for installation. Your exhaust will remain in place and you will be able to work around it for the bolt-on installation. This is a custom fit, Class III hitch…