Suspension Enhancement System Installation - 2009 Dodge Grand Caravan Video

Getting out to our great National Parks is a fantastic way to spend vacation time but you want to get there in comfort before you have to rough it in the wilderness! Suspension enhancement can definitely help. The Coil SumoSprings #CSS-1195R…

The Timbren Rear Suspension Enhancement System #TDVRRT on your 2012 Dodge Grand Caravan do ride close to the axle, but your photo seems closer than normal. We have had some folks mention that when unloaded the Timbren springs ride pretty rough and…

Per Air Lift the leading cause of air bag failure is tearing or punctures from flying debris or interference with other parts underneath the vehicle. It may be worth taking a look at your existing system and inspect for adequate clearance under the…

You will need to use a standard weight distribution kit like the Heavy Duty Trunnion Weight Distribution System #RP66131 for your I-beam trailer. This system would be rated perfectly for your 10k trailer if it was going to be loaded near it's…

You are correct that the welded plate on your trailer frame will obstruct the installation of most weight distribution brackets. The best solution for your case is to use these Chain Hangers #RP58305. These bolt on to the side of your trailer frame…

I reached out to my contact at Trailer Valet regarding the XL Trailer Dolly #TVXL2 you referenced and he said that they have tested this unit to work well on up to a 7-8 degree incline. Based on the 12 inch run and 1.3 inch rise you listed for your…

The issue is that the Roadmaster converter #RM-732 is designed for going the opposite direction that you are wanting. This is designed to take a separate system and combine the circuits and you are wanting to take a combined circuit and separate out…

Because trailer tail light systems combine the stop lamp and turn signals for each side onto a single circuit, you will need to use a vehicle-to-vehicle tail light converter, part #118158 to split the brake light circuit back out. The white wire on…

Trailers use what is called a 2-wire system which means the turn signals and brake lights are on the same circuit. When you try to add separate amber turn signals you will need to separate out the brake light signal using a converter, #118158. On…

Trailer frame weld nuts notoriously end up with rust in them which makes installing hitch hardware pretty difficult. Often times it seems like the solution is to use smaller hitch hardware but the real solution is to clean out the weld nuts so that…

If your trailer has separate turn signals from the brake lights and you want them to remain that way, you will need to use a special converter. On the trailer side, behind the 7-Way, you will attach the Vehicle to Vehicle Taillight Converter,…

When you are looking for the stoplight switch wire, start at the brake pedal and work upward. You will see a cluster of wires very near the pedal that will contain the brake light switch wire. On the 2010 Grand Caravan model we wired for a P2 brake…