Size of Mounting Bolts for CE Smith Front Hanger Bracket # CE14016G
Question:
What size mounting bolts? 7/16? Grade? Galvanized? Thanks,
asked by: Guy L
0
Expert Reply:
The size of bolts for the CE Smith Front Hanger Bracket, part # CE14016G, are as follows:
The 2 top holes on the ends take 7/16" diameter bolts.
The center top hole takes 1/2" in diameter bolts.
The lower spring eye holes take 9/16" diameter bolts.
I have included a picture showing these measurements for you. I recommend using grade 5 galvanized bolts.
expert reply by:
Chris O
0
Product Page this Question was Asked From
CE Smith Front Hanger Bracket for Trailer Slipper Springs - Galvanized Steel - Bolt On - Qty 1
- Trailer Suspension Parts
- Hangers
- Boat Trailer
- Snowmobile Trailer
- Slipper Springs - 1-3/4 Inch
- 9/16 Inch Diameter
- 2-1/4 Inch Tall
- Single Axle
- Tandem Axle
- Triple Axle
- CE Smith
more information >
Continue Researching
- Q&A: Replacement Axle And Leaf Springs For A 4' x 6' Single Axle Trailer
- Q&A: Could Shackle Bolt # 166081 be Used with CE Smith Suspension Hanger # CE14016G
- Article: Slipper Spring Trailer Suspension System Review
- Article: Where to Position the Trailer Axle?
- Q&A: Recommended Bolt On Hangers For Aluminum Frame Trailer
- Q&A: Is It Normal For Open Eye Spring To Hit Frame Of Trailer When Loaded?
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Slipper Spring Recommendation to Replace 31 inch Long Spring
- Q&A: Can Slipper Spring # e29SR Install Below Trailer Axle
- Q&A: What Type of Grease is Used in etrailer Brand Trailer Axle Hubs
- Article: Rust Prevention
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Measure a Trailer Axle