Dimensions for License Plate Holder C31002 When Used in the Upright Position
Question:
im looking at your front receiver licence plate holder. im thinking of turning it over to have move clearence under it. how close is the 2x2 to the bottom of the holder? outside of the reciever to edge of holder?? 2-3??
asked by: david
0
Expert Reply:
I went to our warehouse and measured the license plate holder, and when # C31002 is used in the upright position, the top of the face plate sits 4 inches above the top of the shank. The bottom of the face plate would be 5/8 of an inch below the bottom of the shank.
The edges of the face plate are 5-1/8 inches from the sides of the shank.
expert reply by:
Sarah L
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch License Plate Holder
- Accessories and Parts
- Front Receiver Hitch
- License Plate Holder
- CURT
more information >
Continue Researching
- Q&A: Recommended Hitch For A 2011 Toyota Camry LE V6 With Dual Exhaust
- Q&A: Which Front Hitch that Fits 2022 Ram 2500 Sticks Out Furthest
- Q&A: Length of Shank on the Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver # HT5R
- Q&A: Does the Hollywood Racks LED Light Bar item # HLY54RR Work w/ a 7-Way Connector?
- Q&A: How To Display a License Plate With a Bike Rack Attached
- Q&A: Proper Replacement for Reliable ACT-7.5K Brake Actuator
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Article: How to Install E-Track in 3 Easy Steps