Will Fulton 1200 Pound Swivel Trailer Jack Fit a 2004 Triton 186 PD
Question:
I have a 2004 Triton 186 PD. I need to replace the trailer jack due to the wheel leaning a little. I measured the weld bracket from the top, and the center is 21/2 inches. Is this correct ?
asked by: Joe B
Expert Reply:
The mounting bracket that gets welded to the frame for Fulton swivel jack # FTJ120W0301 is approximately 2-1/4 inches from the top of the bracket to the center of the pilot hole in the middle of the bracket.
It could still potentially work for you if the pilot hole on the bracket you have now is 2-1/4 inches in diameter. The center hole on the jack is 2-1/2 inches. The holes that the jack pin goes through are 3 inches apart on center (up and down and side to side).
Product Page this Question was Asked From
Fulton Round, Snap-Ring Swivel Marine Jack - Weld On - Sidewind - 10" Lift - 1,200 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Replacement Idler Hub For Old Boat Trailer With DICO 45264 Idler Hubs
- Q&A: Is There a Replacement for a Shelby Jack 5856A That Uses Existing Bracket
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Trailer Jack Recommendation for Shelby # 5856A
- Q&A: Recommendation to Replace Shelby 5756A Trailer Jack
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Jack for Bulldog Model 130 Marine Jack
- Q&A: Replacement Parts and Winch for a Profile 2000 Hand Winch
- Article: Best Boat Trailer Jacks
- Article: Trailer Jacks
- Article: Trailer Maintenance Schedule
- Article: Pintle-Hitches
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer