Need Installation Hardware for ProSeries Round A-Frame Topwind Jack # PSEA20000103
Question:
I am buying the pro series round a frame jack topwind 14inch lift 2000 lbs - I need the bolts and nuts to attach it through the 3 provided standard holes. would this part, or 3 sets of this part be the correct one to attach this jack to a standard a frame utility trailer.? if not, what part do I order to get the set of 3 bolts/nuts that I will need?
asked by: Chris H
Expert Reply:
The ProSeries Round A-Frame Topwind Jack # PSEA20000103 that you referenced does not use the Fulton hardware kit # F0933325S00 for installation. That Fulton hardware kit is intended for swing-up jacks rather than A-frame jacks like the ProSeries.
My contact at ProSeries advised that you can locally source and install hardware for this jack. Use 3/8-inch diameter 16-TPI (threads per inch) Grade 5 hardware of 1-1/2-inch length. Longer or shorter hardware of the same rating can be used depending on the mounting requirements of your trailer.
With this jack you can use either detachable foot plate # PS1400700340 or Caster # PS1400750340, but note that the caster wheel has a lower 1200-lb rating. This item will reduce the capacity of the jack to 1200-lbs.
Products Referenced in This Question
Pro Series Detachable Footplate w/ Pin for 2" Diameter Jacks - 2,000 lbs to 5,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- 2 Inch Diameter Tubing
- Pro Series
more information >
Pro Series 6", Detachable Caster w/ Pin for 2" Diameter Jacks - 1,200 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Wheel
- 6 Inch Wheel
- Wheel w Caster Assembly
- 2 Inch Diameter Tubing
- Pro Series
more information >
Pro Series Round, A-Frame Jack - Topwind - 14" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 14 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Pro Series
more information >
Product Page this Question was Asked From
Replacement Hardware Kit for Fulton Swivel Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Fulton
more information >
Continue Researching
- Q&A: Sleeve Washer for Fulton Swivel Jack to Prevent it From Leaning
- Q&A: Size of Bolt Needed for A-Frame Jacks
- Q&A: Hardware Typically Used to Install A-Frame Trailer Jack
- Q&A: Is My Trailers Frame Strong Enough To Use A Weight Distribution Hitch
- Q&A: Replacement Jack For A Dorsey Boat Trailer
- Q&A: Trailer Hub that Uses Bearing # LM67048 for Inner and Outer
- Q&A: What Trailer Tire Size is Most Similar in Diameter to 7-14.5 for Trailer
- Article: Best Boat Trailer Jacks
- Article: Flat Towing Package for 2014-2015 Chevrolet Equinox