Looking for Replacement Hubs for Boat Trailer with 1.06 Inch Diameter Spindles
Question:
I need new hubs for my boat trailer. I don't know the bearing numbers, I can't read them. The spindle is right at 1.06 where the bearings would sit. I need a 5 on 4-1/2 bolt pattern to match my existing wheels.
asked by: Fred
Expert Reply:
Since you successfully measured your spindles, it sounds like you might have a digital caliper lying around somewhere. Measure the hub bore (inside diameter of hub where grease cap sits). If this diameter is 1.98 inches, your existing bearings are # L44649, in which case the # 8-258-5UC1 hub you referenced would indeed be a correct replacement.
Since the hubs are going on a boat trailer, I'd recommend you use galvanized hubs like part # 8-259-50UC1. The hubs are identical to the ones you asked about, but they have a galvanized finish that will provide more corrosion resistance. The hub includes replacement inner and outer bearings, races, grease seal, grease cap and lug nuts.
Products Referenced in This Question
Dexter Trailer Idler Hub Assembly for 2,200-lb Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Hub
- Standard
- L44649
- L44649
- For 2200 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 8 Inch Wheel
- 9 Inch Wheel
- 10 Inch Wheel
- 11 Inch Wheel
- 12 Inch Wheel
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 2,200-lb Axles - 5 on 4-1/2
- Trailer Hubs and Drums
- Hub
- Standard
- L44649
- L44649
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Article: Most Popular Wheel Bearings
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: Replacement Hub, Bearing, and Grease Seal Kit for a UFP H-1062-3 Axle
- Q&A: What is the Length of the Trailer Idler Hub Assembly # TA88545-2
- Q&A: Replacement Hub for Tracker TrailStar Boat Trailer
- Q&A: Which Hubs Can Be Used to Replace the Hubs on a UFP H-1062-3
- Q&A: Cross Referencing 10-9 Replacement Grease Seals for Aliner Trailer
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Where to Position the Trailer Axle?
- Article: Measuring a Trailer Tire
- Article: Slipper Spring Trailer Suspension System Review