Wiring Optronics Uni-Lite Clearance Lights on a Motorcycle for Additional Turn Signals
Question:
i asked a question earlier about mounting these as turnsignal reply said ground white wire 2 bare metal then hook up the hot black but since im using factory turnsignal hardware wires there already ground with relays and ect so ?? can i just hookup and go or???
asked by: Tim
0
Expert Reply:
You can tap the power wire from the Uni-Lite, # MCL11CAKB, to the factory turn signal wire but you will still need to ground the light as well. You can try using an existing ground for another light but in the event that does not work you will need to ground the light to the metal frame.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Clear Lens - Amber
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: How to Power Trailer Dome Light When Not Connected to Tow Vehicle
- Q&A: Options for Adding Interior Lighting to Enclosed Cargo Trailer
- Q&A: Fuse Location for Trailer Brake Controller on a 2005 Chevy Silverado
- Q&A: Location of the 40-Amp Fuse for the 2006 Chevrolet Silverado Tow Package
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Difference Between 205/65-10 and 20.5 x 8-10 Trailer Tire Sizes
- Q&A: Modern Tire Size Equivalent for 20.5x8-10
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Article: Car Camping Checklist
- Article: Stability Control for Heavy Duty Vehicles
- Article: Brake Controller Installation: Starting from Scratch