Would the Curt 7-Way Bracket # C58000 fit Factory 7-way of Nissan Xterra
Question:
Hello. Will the Nissan Xterra factory 7 pin harness fit this bracket? Thanks.
asked by: Rick
0
Expert Reply:
Most likely yes, but the diameter of the hole where your 7-way would install is 2 inches which is the standard size for 7-way mounting brackets. As long as your 7-way would fit in the 2 inch diameter this bracket would work well for you.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Easy Mount Bracket for 4- or 5-Way Flat and 6- or 7-Way Trailer Connectors - 2" Hitch
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Flat
- 5 Flat
- 6 Round
- 7 Round
- CURT
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Hitch for a 2024 Honda Pilot
- Q&A: Do I Need Additional Fuses for the Main Fuse Box on a 2024 Honda Pilot to Power a Wiring Harness?
- Q&A: Where to Mount 7-Way of ETB7 on 2023 Subaru Outback Wagon
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Draw Tite Trailer Hitch Recommendation for 2024 Honda Passport Black Edition
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed to Add 7-Way to 2024 Hyundai Palisade Limited
- Q&A: Installation Process Of The Curt 7-Way Connector On A 2022 Honda Pilot
- Q&A: How To Mount 7-Way Connector To Curt Trailer Hitch Receiver C15810
- Article: Steel vs. Aluminum Ball Mounts
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)