Can I use a Fulton F2 Trailer Jack with a Tongue Height of 24 Inches
Question:
I am building an offroad trailer. My tongue height is 24 inches. Id like to run a Fulton F2 trailer jack. Is there a model that would work? My preference would be weld on as the trailer is aluminum.
asked by: Jeremy S
0
Expert Reply:
The Fulton F2 # F1413050334 would work great for your needs! I have also linked a video for you to view. I measured the jack from the ground up to its maximum extension of the center of the bracket which is 28.5 inches.
Also, I would consult with a professional welder prior to welding the Fulton F2 # F1413050334 to aluminum.
expert reply by:
Chris B
0
Product Page this Question was Asked From
Fulton F2 Swing-Up, Wide-Track Trailer Jack, 8" Single Wheel Sidewind, Weld-On - 1,600 lbs
- Trailer Jack
- Boat Trailer
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Alloy Aluminum
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Weld On Mount for Fulton Jack F2 Jack Come with It
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Roadmaster Invisibrake Installation in 2020 Jeep Glaidator Overland
- Q&A: Replacement Boat Trailer Jack Non-Swiveling For Clearance Of HitchMate Boat Trailer Step
- Q&A: Can Fastway Flip Automatic Fold-Up Jack Foot be Used When Trailer is Occupied
- Q&A: I am Looking for the Dexter E-Z Flex Equalizer part # 013-143-03
- Q&A: Best SumoSprings For 2013 Ford F-150 For Towing Travel Trailer
- Article: How Long Can You Boondock in an RV?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Tire Sizing
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Trailer Lighting Requirements
- Article: How Much Does a Boat and Trailer Weigh?