Electric Jack Recommendation with Positive Stop to Prevent Gear Damage From Over-Extension
Question:
Does this unit have a positive stop to avoid damaging the unit in the event the jack is fully extended?
asked by: Jim
0
Expert Reply:
For a jack that has a positive stop that will prevent gear damage due to jack over-extension you would want the Husky Brute Electric Trailer Jack part # HT87247.
This jack also has a low-friction ball bearing screw to minimize wear, noise, and heat.
The Stromberg Carlson Jack # JET-2500 does not have a positive stop in the jack.
I attached an install and review video for you to check out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Electric A-Frame Tongue Jack - 18" Lift - 2,500 lbs
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 2001 - 3000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2016-2018 Ford Focus
- Q&A: How to Tow a 2016 Ford Focus Behind a Motorhome
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: What Weight Measurement is Referenced When Choosing a Trailer Jack
- Q&A: Trailer Jacks Manufactured in the USA
- Article: Determining Trailer Tongue Weight
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Q&A: Recommended Replacement For A Jensen JWM70A RV Stereo
- Q&A: Replacement Toggle Switch for Ultra-Fab Jack that Lifts But Won't Lower
- Q&A: Replacement Motor and Blades for Ventline Ventadome V3094