Length of the Pin and Retainer for Ram Coupler
Question:
how long is the pin for this part?
asked by: Ally
0
Expert Reply:
The pin measures 3 inches from top of head to end of pin. It has a usable length of 2-3/4 inches from the bottom of the head to the clasp.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Pin for Ram Sleeve Lock Couplers - 7,000 lbs and 12,500 lbs
- Accessories and Parts
- A-Frame Trailer Coupler
- Adjustable Trailer Coupler
- Pins and Clips
- etrailer
more information >
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Most Popular Wheel Bearings
- Q&A: Bolt Pattern of Dutton-Lainson Drop Leg Jack Part # DL22320
- Q&A: Parts Needed To Add Electric Brakes to an AutoFlex 3,750 Axle
- Article: Fifth Wheel Installation Kit 30095 using adapter kit 58425
- Q&A: Brake Controller Installation in 2019 Ford Ranger
- Q&A: How Visible is the Curt Class III Hitch # 13354 when installed on a 2010 Infiniti FX35
- Q&A: Can The Stealth Hitches Receiver For a 2018 Porsche Macan Be Installed as a DIY Installation?
- Article: Double-Eye Trailer Suspension System Review
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Where to Position the Trailer Axle?
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Recommended Replacement Trailer Jack Wheel That Has A Rubber Tire
- Q&A: Will the Demco Solenoid Kit # DM5837 Fit Demco Hydraulic Brake Actuator # DM8759812