How To Re-Pair an Even Brake to a Transmitter After Screen Just Reads Even Brake

Question:

Our system stopped working between trips. Everything is getting power. The monitor has a green light in the upper rt. hand corner and the display reads Even Brake. When I pushed the ion arrows every section was blank except the serial number. Im thinking maybe we need to re-sync the receiver with the sender. If so how do u do that?

asked by: Marj

Expert Reply:

According to Roadmaster this means that the monitor is not programmed to the ICX transmitter. The ICX transmitter and the motorhome monitor are programmed as a set but you need to reprogram yours to match apparently.

Press the Dim button on the motorhome monitor after plugging it in for about 6 seconds until the LCD reads, "receiver in learn mode."

Release the Dim button and it should read "Learning ICX #1 --Advance OK."

Press the Test button on the Even Brake Touch pad control panel. It should begin a self-diagnostic test. Once complete the test light will illuminate green indicating it is paired and ready to go.

If it is red then there is a problem and you should check the motorhome monitor for detailed information.

expert reply by: Jameson C