Length of Mounting Hardware Supplied With MaxxTow Adjustable Wheel Chock

Question:

mounting into 2x6 treated lumber. Would these mounting screws be long enough ? Length ? Little confused by the Q about removing the chock in the Q department. This chock is removable isnt it ? Can extra screws be purchased for further mountings ?

asked by: Doug B

Expert Reply:

The 4 carriage bolts (and related hardware) supplied with the MaxxTow Adjustable Wheel Chock (DISCONTINUED) MT70075 are intended to semi-permanently install this unit on the floor of a trailer. This wheel chock is not intended for routine removal and re-installation although it certainly could be taken off your trailer by removing the mounting hardware. The carriage bolts supplied are 3-inches long overall and include a washer, plastic spacer and nylock hex nut.

If your trailer's floor is thicker and requires longer hardware you can easily source locally similar carriage bolts that better suit your application.

If you want to easilt remove the chock you might instead consider # TWSPWC from Tow-Rax. It is also available in black as # TWSPWM.

expert reply by: Adam R