Hub Replacement Recommendation Where Races are L6811 and L44610
Question:
i can only identify numbers on race which are L68111 and L44610 nothing on the bearings themselves.. I believe the bearings to be L68149 and 44649 would this be accurate? also the rear seals have previously been replaced with numbers 203015 however the rubber seal doesnt seem to be as snug as i should think they should be . My question is do all these numbers match the 84545UC1-EZ as near as you can tell?
asked by: Rick
Expert Reply:
Yes, the Trailer Hub Assembly # 84545UC1-EZ that you referenced would be the correct hub for you. Based on the race numbers you listed the bearings that you have are the L68149 and 44649 so the # 84545UC1-EZ would be the correct hub for you as long as your wheels have a 5 on 4-1/2 inch bolt pattern.
If you have a different bolt pattern check out the link I attached shows all of the hubs that would install on your spindle. I attached an FAQ on determining bolt patterns for you to check out.
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub
- EZ Lube
- Pre-Greased
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Replacement for Dexter 8-248 Idler Hub
- Q&A: Right Replacement Hubs for a Trailer with 3500 Pound Axle and 5 on 4-1/2 Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Replacement Trailer Hub for Dexter 8-248
- Q&A: Replacement Trailer Hub Assembly for Dexter 8-248 Hubs
- Article: Trailer Tire Sizing
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: How To Find Correct Hubs for 3,700 Lb Axis Products Trailer Axle
- Q&A: Are the Safety Struts for the etrailer Cargo Carrier Included
- Q&A: Trailer Idler Hubs With L44649 Inner and Outer Bearings And 1-1/4 Grease Seal
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams