Wiring Diagram for the Bulldog Powered-Drive Kit # BD1824200100
Question:
Can I mount the unit on the left side? It would be better because of the spare tire on the right side. The picture shows it on the left. IN that case, I would believe the black would become the positive for the switch. Please advise about how to wire using the terminal box. I dont understand what wires go where?
asked by: Harvey S
Expert Reply:
I spoke to my contact at Bulldog and he informed me that the Bulldog Powered Drive Kit part # BD1824200100 that you referenced can only be installed on the driver side of the trailer due to how the gears of the jack setup.
To see how it all wires up check out the wiring diagram I attached that I took from the installation instructions for this kit.
Product Page this Question was Asked From
Bulldog Powered-Drive Kit for Single-Speed Jacks w/ 12,000-lb Capacity
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Powered-Drive Kit
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: access door
- Shop: Kenda 4.80-12 Bias Trailer Tire with 12" White Wheel - 4 on 4 - Load Range C
- Article: Pintle-Hitches
- Search Results: hitch lock
- Shop: B&W Tow & Stow 2-Ball Mount - 3" Hitch - 4-1/2" Drop, 4" Rise - 21K - Black
- Shop: BOLT Trailer Hitch Receiver Lock - 2", 2-1/2", and 3" Hitches - Ford Side-Cut Key
- Shop: BOLT brand vehicle and hitch locks
- Search Results: 5 on 475
- Shop: Aluminum Liger Trailer Wheel - 16" x 6" Rim - 6 on 5-1/2 - Glossy Black
- Shop: Lionshead Trailer Wheel Lug Nut - 1/2"-20 - Stainless Steel - Qty 1
- Shop: Aluminum Lion Trailer Wheel - 15" x 5" Rim - 5 on 4-1/2 - Glossy Black
- Shop: Enclosed Cargo Trailer License Plate Holder, Plastic - Black
- Search Results: e84yr
- Video: Lionshead Tires and Wheels LHLR103 Review
- Shop: Floor Mats
- Q&A: Trailer Wheel with Bolt Pattern 5 on 4-3/4 inches
- Article: How to Measure for Trailer Hitch Drop
- Search Results: hubcaps
- Q&A: Determining Correct Replacement Hubs for Dexter 8-286 Hubs on 2,500 Pound Axle
- Search Results: trailer wheel
- Search Results: 480~12
- Q&A: How to Pick Out Replacement Bearings/Races for a Wesco Boat Trailer
- Shop: Trailer Hitch
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Q&A: Using 1 or 2 Electric Jack Motors for Bulldog Single Speed Jacks with 12,000 Pound Capacity
- Q&A: Can Bulldog 12,000lb Trailer Jack Be Adapted To Be Raised/Lowered With Electric Impact?
- Q&A: Can Ram Trailer Landing Gear Jacks be Converted to 2 Speed
- Q&A: Why Would My Hopkins Break Away Switch Blink
- Shop: Brake Controller
- Video: Bulldog Powered-Drive Kit Review