Does the Roadmaster Front Suspension Bar # RM-1109-200 Replace Front Sway Bar On a 2003 P32 Chassis
Question:
Does the RM-1109-200 replace the total factory swaybar and brackets? and do you have the RM wider braket spreader? Thanks,
asked by: Bob E
0
Expert Reply:
The Roadmaster Front Suspension Bar for Motor Homes with Factory Anti-Sway Bar # RM-1109-200 that you referenced does not replace the factory sway bar. It installs with it to balance weight transfer and reduce body roll on your 2003 P32 chassis.
The part # RM-1109-200 is also known as the Roadmaster Spreader bar.
Check out the installation instructions I attached for this product.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Roadmaster Front Suspension Bar for Motorhomes with Factory Anti-Sway Bar - 1-1/2" Diameter
- Anti-Sway Bars
- Anti-Sway Bar
- Front
- 1-1/2 Inch Diameter
- Steel w Polyurethane Bushing
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Steering Stabilizer Recommendation for 2018 Ford E-450 Jayco Grayhawk Prestige
- Q&A: Replacement Step Tread Grip Tape
- Q&A: Steering Stabilizer and Front/Rear Anti-Sway Bars for a 1995 Georgie Boy on Chevy P30 Chassis
- Q&A: How To Prevent Front End Sagging on a 2005 Winnebago Sightseer with Workhorse P32 Chassis
- Q&A: Recommendation for a Front Sway Bar on a 2000 Itasca Sunrise 35 Foot with a P32 Workhorse Chassis
- Q&A: Are There Air Bags for a 2002 Workhorse P42 Chassis
- Q&A: Replacement Controller for Kwikee Series 32 Step Assembly Part 909506000
- Article: Determining Trailer Tongue Weight
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Manually Light an RV Oven, Furnace, Water Heater, or Refrigerator
- Article: How to Clean RV Water Heater