Where to Install Redline 2-Piece Polypropylene Trailer Vent # HMAV2-AVT2
Question:
where to put them in the bottom or up the trailer, in front or rear É
asked by: Luc L
Helpful Expert Reply:
The Redline 2-Piece Polypropylene Trailer Vent # HMAV2-AVT2 can be installed in any convenient location on your enclosed trailer where you have or can make a 3-inch diameter hole. These vents will work best when used in multiples, with some near the ceiling and some near the floor, to allow cooler air to enter through the lower vents and hotter air to exit through the upper vents.
I recommend you use a sealant for installation, such as silicone caulk or Silicone Sealant # 0160297. You'll also need to supply 9 installation screws per vent, such as either # 31071 for sheet metal or # 30587 for wood.
Products Referenced in This Question
TremPro 644 Silicone Sealant - 10.1-Fl-Oz Cartridge - White
- Lubricants Sealants Adhesives
- Sealant
- Multi-Purpose Sealant
- 10.1 oz
- Flint Hill Goods
more information >
Wood Screw - 8 x 3/4" Slotted Round Head
- Accessories and Parts
- Tie Down Anchors
- Hardware
- Screws
- 3/4 Inch Long
- Wood Screws
- Flint Hill Goods
more information >
Zinc Sheet Metal Screw - 8 x 3/4" Indented Hex Washer Head - Hex Slotted Drive
- Accessories and Parts
- Tie Down Anchors
- Hardware
- Screws
- 3/4 Inch Long
- Sheet Metal Screw
- Flint Hill Goods
more information >
Product Page this Question was Asked From
2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - Black
- RV Vents and Fans
- Vent
- Wall Vent
- No Fan
- 6W x 8L Inch
- Plastic
- Black
- Redline
more information >
Continue Researching
- Q&A: Will Adding a Trailer Vent Reduce Condensation
- Shop: 2-Piece Exterior Wall Vent for Enclosed Trailers - Polypropylene - 3" Diameter Hole - Black
- Shop: Wood Screw - 8 x 3/4" Slotted Round Head
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Brake Shoes for 10 x 1-3/4-inch Brakes on 22-Foot Travel Trailer with 3500-lb Axles
- Q&A: Looking for Replacement Trailer Lamp Lens # 1A-S-20
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Maintenance Schedule
- Q&A: Side Wall Vent Recommendation for an Enclosed Trailer for Maximum Air Flow
- Q&A: Recommended Parts to Rewire an Old Trailer w/ Brakes
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Trailer Hitch Extension to Tow Motorcycle with 2012 Chevy Silverado 2500 with Lance Camper
- Article: Rooftop Cargo Carriers
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)