What Material is Butterfly Vent for Trailers 371800 Made Out Of
Question:
Is this an aluminum vent with 4 mounting holes as used on stock and horse trailers?
asked by: Dan
0
Expert Reply:
This butterfly vent is typically used on horse, stock, dog and various other types of trailers. It is a full 7 1/2 inch in diameter with four mounting holes around the edge. The polished aluminum is attractive as well as being a useful source of ventilation.
expert reply by:
Heather A
0
![Heather A](https://images.etrailer.com/static/images/catg/people/1131_tn.jpg)
Product Page this Question was Asked From
Continue Researching
- Q&A: Replacement 3/8 Diameter Plunger Pin Assembly
- Q&A: Recommendation For Attaching Horse Trailer Side Pads
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement For A Magnadyne RV5090 RV Stereo System
- Q&A: Brake Controller Wiring Harness for 2006 Ford F-53 Chassis and P3 Brake Controller
- Q&A: Fuse Location for Installation of Curt Wiring Harness on 2018 Toyota Highlander
- Q&A: Where is 10 Pin Connector to Install Trailer Wiring on 2018 Lexus RX 350L
- Q&A: Does The Kenda ST205/75R14 Radial Trailer Tire and Wheel # AM32153 Come Balanced
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Types of Bumpers
- Article: Trailer Tire Sizing
- Article: Trailer Lighting Requirements